User manual

CLI Commands and Messages
CLI Command List
8-66 July 2004 Wide Bank 28 DS3 - Release 2.4
RESULTS
Name: Results of Test
Purpose: Show the results from the last test performed on an interface. Tests are activated by the
test command (see TEST on page 8-79).
This command is performed automatically when the test command executes. You can
also use this command at any time to display the most recent results of a test. For
example, if the unit was just powered up, the test all option will show the results of the
power-on self-test.
Security: ro and above
Syntax: results {all|ds1 [number|range|all]|
ds1card [n|spare]|ds3|fan [n|all]}
Example: results all
DS1 Card 1 Self Test: Pass
DS1 Card 2 Self Test: Pass
DS1 Card 3 Self Test: Pass
DS1 Card 4 Self Test: Pass
DS1 Card 5 Self Test: Pass
DS1 Card 6 Self Test: Pass
DS1 Card 7 Self Test: Pass
DS1 Spare Card Self Test: Pass
tl1 networkid ""
tl1 password ""
tl1 portnumber 9999
Field Description
all Show results for all tests
ds1 number Show results for low-speed DS1/E1 interface number, 1 to 28
ds1 range Show results for a range of low-speed channels.
Range is separated by a hyphen as in 5-8
ds1 all Show results for all low-speed interfaces
ds1card n Show results for DS1 card number, 1 to 7
ds1card spare Show results for spare card
ds3 Show results for high-speed DS3 interface
fan n Show results for fan number, A or B
fan all Show results for both fans
Parameter Default Comments