User manual

CLI Commands and Messages
CLI Command List
8-64 July 2004 Wide Bank 28 DS3 - Release 2.4
Security: rw and above with basic security; secu with Security Upgrade
See Security on page 1-5 for an overview of basic security and the Security Upgrade
option.
Syntax: restore {defaults|temp copy|tftp ipaddr "filename"}
Example: restore tftp 192.128.17.10 "configuration"
Restore the configuration file from TFTP server.
Example: restore defaults
Restore the factory default settings (see table below).
Field Description
defaults Restore the factory defaults. See table below.
temp copy Retrieve a temp copy from RAM (see
TEMP COPY on page 8-79)
tftp Retrieve a previously saved configuration file from a TFTP server
(see
SAVE on page 8-68)
ipaddr IP address of TFTP server where file is located, in the format
xxx.xxx.xxx.xxx where xxx is a number from 0 to 255
"filename" File name including path. Must be enclosed in quotes.
Parameter Default Comments
alarmout no normally open contacts
alarms protected ds3_selftest minor standby Controller fail
arm on
autocopy on
ds1 n enable n = 1 to 28
ds1 n circuitid "DS1 n" n = 1 to 28
ds1 n equipment off
ds1 n length dsx0
ds1 n line off
ds1 n linecode b8zs
ds1 n loopdetect off
ds1 n metallic off
ds1 n send off
ds1 ains off auto in-service detection
ds1 ains delay 2 hours
ds1 protection on
ds3 circuitid "DS3"