User manual

CLI Commands and Messages
CLI Command List
8-62 July 2004 Wide Bank 28 DS3 - Release 2.4
Example: ls 5 send csu loopup drop
Send ls #5 csu loopup code toward low-speed drop side.
Setting Description
off Send no code or stop sending code
ais Send alarm indication signal (AIS) toward the low-speed side
cbit loopup Send C-bit loopup request toward the far-end low-speed circuits on
the DS3 network side using DS3 C-bit FEAC code words. DS3 C-bit
parity framing mode only.
cbit loopdown Send C-bit loopdown request toward the far-end low-speed circuits
on the DS3 network side using DS3 C-bit FEAC code words. DS3
C-bit parity framing mode only
cbit loopup drop Send CSU loopup code (10000) toward the low-speed side and wait
for acknowledge
csu loopup drop Send CSU loopup code (10000) toward the low-speed side and wait
for acknowledge
csu loopup
network
Send a C-bit loopup code toward the far-end low-speed circuit on the
DS3 csu network side. DS3 M23 framing mode only
csu loopdown
drop
Send CSU loopdown code (100) toward the low-speed side and wait
for acknowledge
csu loopdown
network
Send a C-bit loopdown code toward the far-end low-speed circuit on
the DS3 csu network side. DS3 M23 framing mode only
niu loopup Send NIU loopup code request over DS3 toward DS1 NIU at remote
end
niu loopdown Send NIU loopdown code request over DS3 toward DS1 NIU at
remote end
prbs drop Send PRBS code toward the low-speed side. The manager monitors
the low-speed receive to detect PRBS errors and will display the error
count, error rate, and synchronization state (sync/no sync).
prbs network Send PRBS code toward the network side
prbs test drop Perform Automated PRBS Test of DS1 drop side. The Wide Bank
will send PRBS for 10 seconds and then display the test result.