User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 8-61
CLI Commands and Messages
CLI Command List
LS PROTECT
Name: LS Protection
Purpose: Configure automatic low-speed electronics protection.
Security: Set - rw and above
Show - ro and above
Syntax: ls protect [on|off]
Example: ls protect on
Enables the DS1 Electronics Protection. This is the default.
LS SEND
Name: LS Send Code
Purpose: Configure low-speed circuit to send a code. This command permits a variety of bit
pattern codes to be sent toward the low-speed or network side. Each low-speed channel
includes a pseudo-random bit sequence (PRBS) code generator and detector. (see
chapter 7).
Security: rw and above
Syntax: ls {number|range|list|all} send {setting}
Field Description
ls protect Use the command by itself to show the current setting.
protect Set the electronics protection mode
on Enable low-speed electronics protection. This is the default.
off Disable low-speed electronics protection.
Field Description
number Low-speed interface number, 1 to 28
range A range of low-speed channels separated by a hyphen as in 5-8
list A list of low-speed channels separated by commas as in 1,3,5,9
all All low-speed interfaces
send Send a code pattern (see settings in following table)