User manual

CLI Commands and Messages
CLI Command List
8-60 July 2004 Wide Bank 28 DS3 - Release 2.4
Syntax: ls {number|range|list} pm threshold [interval error value]
Example: ls 5 pm threshold
The following message shows the default values defined in GR-820-CORE.
- LS Circuit 5
Performance Thresholds: 15 min. 1 hour 1 day
-------- -------- --------
coding violations - line: 13340 40020 133400
errored seconds - line: 65 195 648
Example: ds1 1-4 pm threshold min15 cvl 32
Set DS1 circuits 1 to 4 for PM threshold CVLs to 32 for each 15-minute report interval.
Field Description
ls pm threshold Use the command by itself to show the current setting
number Low-speed interface number, 1 to 28
range A range of low-speed channels separated by a hyphen as in 5-8
list A list of low-speed channels separated by commas as in 1,3,5,9
interval Specify measurement time interval (see Interval table below)
error Specify error type (see Error table below)
value An integer value specifying the threshold error count for the
measurement interval.
Set to zero to disable threshold crossing alerts.
Interval Description
min15
15 minutes
hour
One hour
day
One day
Error Description
cvl Code Violations - Line. The total number of line code violations that
have been detected during the measurement interval. A CVL is the
occurrence of a Bipolar Violation (BPV).
esl
Errored Seconds - Line. The number of one-second intervals
containing one or more CVLs or one or more Loss of Signal (LOS)
defects.