User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 8-59
CLI Commands and Messages
CLI Command List
Example: lsmode ds1ls
Set CLI to use LS commands to configure DS1 circuits.
Example: lsmode ds1
Set CLI to use legacy DS1 commands to configure DS1 circuits.
LS MOVE
Name: LS Move Channel
Purpose: Move low-speed channel to home card or spare card. Moving a circuit home does not
reset the revertive state (REVERTIVE on page 8-67).
Security: rw and above
Syntax: ls {number|range|list|all} move {home|spare}
Example: ls 13 move spare
Move LS #13 from home card to spare card.
LS PM THRESHOLD
Name: LS Performance Monitor Threshold
Purpose: Set or show the threshold value for PM statistics. When the threshold is exceeded, the
Wide Bank will log a CLI event and send an automatic TL1 message. The performance
threshold function complies with Telcordia GR-820-CORE.
Security: Set - rw and above
Show - ro and above
Field Description
number Low-speed interface number, 1 to 28
range A range of low-speed channels separated by a hyphen as in 5-8
list A list of low-speed channels separated by commas as in 1,3,5,9
all All low-speed interfaces
move Move low-speed channel
home Move channel to home card
spare Move channel to spare card