User manual

CLI Commands and Messages
CLI Command List
8-58 July 2004 Wide Bank 28 DS3 - Release 2.4
Example: ls 11 metallic on
Apply LS #11 metallic loopback.
LSMODE
Name: Low-Speed Mode
Purpose: Set the low-speed mode on the Wide Bank 28 DS3. The CLI will behave accordingly,
regardless of the type of low-speed circuits present in your Wide Bank. This command
allows you to configure CLI operation to respond to legacy DS1 commands or to new
low-speed (LS) commands for DS1 or E1 circuit configurations. When the LSMODE
is set to DS1, you must use the DS1 commands.
Note: When the LSMODE is set to DS1, you must use the DS1 commands. When the
LSMODE is set to either DS1LS or E1LS, you must use the LS commands. The LS
command operates just like the DS1 command, except that the responses are specific
to the DS1 or E1 interface type. In the DS1LS mode, the low-speed references in
command responses are the same as for the DS1 mode. In E1LS mode, the low-speed
references in command responses are for E1 (each E1 card has only three active
circuits; the fourth, unused, circuit on an E1 card is called CIR). See DS1 on page 8-21
and LS on page 8-50.
Security: rw and above
Syntax: lsmode {ds1|ds1ls|e1ls}
Field Description
number Low-speed interface number, 1 to 28
range A range of low-speed channels separated by a hyphen as in 5-8
list A list of low-speed channels separated by commas as in 1,3,5,9
all All low-speed interfaces
metallic Send metallic loopback toward low-speed side
on Apply metallic loopback
off Disable metallic loopback
Field Description
ds1 Set to DS1 mode using DS1 commands to configure the DS1
interfaces. This is the default mode and is compatible with legacy
Wide Banks having only DS1 low-speed cards.
ds1ls Set to DS1LS mode using LS commands to configure the DS1
interfaces
e1ls Set to E1LS mode using LS commands to configure the E1 interfaces