User manual

CLI Commands and Messages
CLI Command List
8-56 July 2004 Wide Bank 28 DS3 - Release 2.4
LS LINE
Name: LS Line Loopback
Purpose: Configure line loopback toward low-speed side (see chapter 7).
Security: rw and above
Syntax: ls {number|range|list|all} line {on|off}
Example: ls 9 line on
Apply LS #9 line loopback.
LS LINECODE
Name: LS Line Coding
Purpose: Set line coding for low-speed circuits. DS1 circuits use AMI or B8ZS. E1 circuits are
fixed at HDB3.
Security: rw and above
Syntax: ls {number|range|list|all} linecode {ami|b8zs}
Field Description
number Low-speed interface number, 1 to 28
range A range of low-speed channels separated by a hyphen as in 5-8
list A list of low-speed channels separated by commas as in 1,3,5,9
all All low-speed interfaces
line Send line loopback toward low-speed side
on Apply line loopback
off Remove line loopback
Field Description
number Low-speed interface number, 1 to 28
range A range of low-speed channels separated by a hyphen as in 5-8
list A list of low-speed channels separated by commas as in 1,3,5,9
all All low-speed interfaces
linecode Configure DS1 line coding.
E1 circuits are fixed at hdb3 (High Density Bipolar 3).
ami Alternate Mark Inversion
b8zs Binary 8-Zero Substitution