User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 8-53
CLI Commands and Messages
CLI Command List
LS CIRCUITID
Name: LS Circuit Identifier
Purpose: Set the low-speed circuit identification string (transmission vendor’s identification),
which is used for SNMP display only.
Security: rw and above
Syntax: ls {number|range|list|all} circuitid {"string"}
Example: ls 1 circuitid "MUX2-1"
Set LS #1 circuit identifier.
LS ENABLE/DISABLE
CAUTION! DISABLING AN INTERFACE WILL DISRUPT SERVICE.
Name:
LS Interface Enable/Disable
Purpose: Activate or deactivate a low-speed interface (normally used for SNMP managed
systems.
Security: rw and above
Syntax: ls {number|range|list|all} {enable|disable}
Field Description
number Low-speed interface number, 1 to 28
range A range of low-speed channels separated by a hyphen as in 5-8
list A list of low-speed channels separated by commas as in 1,3,5,9
all All low-speed interfaces
circuitid Set low-speed circuit identification string
"string" Alphanumeric string enclosed in quotes, as per RFC 1406
requirement for SNMP MIBs