User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 8-51
CLI Commands and Messages
CLI Command List
Syntax: ls {number|range|list|all}
Example: ls 5
- LS Circuit 5
ds1 5 circuitid "DS1 5"
ds1 5 enable
ds1 5 equipment off
ds1 5 length dsx0
ds1 5 line off
ds1 5 linecode b8zs
ds1 5 loopdetect off
ds1 5 metallic off
ds1 5 send off
Performance Thresholds: 15 min. 1 hour 1 day
-------- -------- --------
coding violations - line: 0 0 0
errored seconds - line: 0 0 0
Example: ls all
Display configuration settings for all low-speed interfaces.
LS AINS
Name: LS Automatic In-Service Detection
Purpose: Set low-speed alarm mode for automatic detection of new service connections. This
command allows service providers to configure low-speed drops before connections or
facilities are available. When automatic in-service detection is enabled, a disabled low-
speed channel can be enabled (set in service) while a Loss of Signal (LOS) condition
is present, and the Wide Bank will inhibit LOS alarm reporting for that channel until a
new service connection has been established for the specified delay time.
Note: Following a DC power interruption, the LOS inhibit will be disabled on all
channels, causing an LOS alarm on any DS1 or E1 that is enabled but not in service.
Field Description
number Low-speed interface number, 1 to 28
range A range of low-speed channels separated by a hyphen as in 5-8
list A list of low-speed channels separated by commas as in 1,3,5,9
all All low-speed interfaces