User manual

CLI Commands and Messages
CLI Command List
8-50 July 2004 Wide Bank 28 DS3 - Release 2.4
Example: load xmodem
Initiates a download from a terminal emulation program using Xmodem protocol. The
file name is entered in the terminal emulation program.
Example: load tftp 192.168.2.90 "c:\directory\filename"
Initiates a download from a TFTP server on the LAN. The path and file name must be
enclosed in quotes.
LOG
Name: Log
Purpose: Show event history.
Security: ro and above
Syntax: log
Index Time Date Alarm
----- ---- ---- ---------------------------------
9 01:00:30 01/01/97 Self Test Pass
8 01:00:02 01/01/97 DS3 Test Pass
7 01:00:00 01/01/97 Power on
6 01:01:45 01/01/97 Log out
5 01:00:35 01/01/97 Log in
4 01:00:29 01/01/97 Self Test Pass
3 01:00:03 01/01/97 DS3 Test Pass
2 01:00:00 01/01/97 Default Configuration Installed
1 01:00:00 01/01/97 Power on
LS
Name: LS Configuration Settings
Purpose: Show the DS1 or E1 low-speed interface settings. The command followed by the
interface number displays the current configuration. The command, with a move
option, gives control of a low-speed interface to a spare circuit for maintenance or when
a low-speed card is to be removed.
Note: When the LSMODE is set to DS1, you must use the DS1 commands. When the
LSMODE is set to either DS1LS or E1LS, you must use the LS commands. The LS
command operates just like the DS1 command, except that the responses are specific
to the DS1 or E1 interface type. In the DS1LS mode, the low-speed references in
command responses are the same as for the DS1 mode. In E1LS mode, the low-speed
references in command responses are for E1 (each E1 card has only three active
circuits; the fourth, unused, circuit on an E1 card is called CIR). See LSMODE on
page 8-58 and DS1 on page 8-21.
Security: ro and above