User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 8-47
CLI Commands and Messages
CLI Command List
HOUR
Name: Hour Performance Report
Purpose: Show the one-hour performance report for an interface. The performance statistics
displayed conform to SNMP MIBs 1406 and 1407 reporting requirements.
For 24-hour statistics, see DAY on page 8-19.
Security: ro and above
Syntax: hour {ds1 number|ds3|ds3far}
Example: hour ds1 5
15-Minute Interval Statistics for DS1 1 at 06:08:23 05/09/2001
STATISTIC \ INTERVAL Current 1 2 3 4 Hour
--------------------- -------- -------- -------- -------- -------- ---------
Unavailable Sec 0 0 - - - 0
Sev Errored Sec 0 0 - - - 0
Errored Sec 0 3 - - - 3
Loss of Signal Sec 0 0 - - - 0
Line Errored Sec 0 3 - - - 3
Controlled Slip Sec 0 0 - - - 0
Degraded Min 0 0 - - - 0
Protected Sec 0 0 - - - 0
Loopback Sec 0 0 - - - 0
PRBS Sync Sec 0 2 - - - 2
Protected Cnt 0 0 - - - 0
LCV Error Cnt 0 371 - - - 371
PRBS Error Cnt 0 66 - - - 66
Elapsed Sec 175 LCV Error Rate 0
Valid Intervals 1 PRBS Error Rate No Sync.
Example: hour ds3far
15-Minute Interval Statistics for Far-end DS3 at 06:09:47 05/09/2001
STATISTIC \ INTERVAL Current 1 2 3 4 Hour
--------------------- -------- -------- -------- -------- -------- ---------
FE Unavailable Sec 0 0 0 0 0 0
FE C-bit Sev Err Sec 0 0 0 0 0 0
FE C-bit Errored Sec 0 0 0 0 0 0
FE C-Parity Err Cnt 0 0 0 0 0 0
Field Description
ds1 number Display performance for a DS1, where number = 1 to 28
ds3 Display performance for the DS3 interface
ds3far Display performance for far-end DS3 (valid only with C-bit framing)