User manual

CLI Commands and Messages
CLI Command List
8-46 July 2004 Wide Bank 28 DS3 - Release 2.4
Example: ffo present on
HELP, ?
Name: Help
Purpose: Use this command to display a list of available commands. There are two levels of help
provided by typing ? or help. The information displayed depends on the user security
level.
Security: ro and above
Syntax: [command name] {?|help}
Example: help
? .................... For partial command help, type ? after
entering any partial command in question
help ................. For full command help, type "help" after
entering any partial command in question
Example: ip help
ip ............................. Set/Display IP Addresses xxx.xxx.xxx.xxx
address ipaddr ............. Set IP Address
mask ipaddr ............. Set Subnet Mask
gateway ipaddr ............. Set IP Address of Gateway
nms1 ipaddr ............. Set IP Address of NMS1 (trap)
nms2 ipaddr ............. Set IP Address of NMS2 (trap)
nms3 ipaddr ............. Set IP Address of NMS3 (trap)
ppp ipaddr ............. Set IP Address of Other End of PPP Link
route ...................... Set Route for Outbound IP Traffic
ethernet ............... Ethernet
ppp .................... PPP over DS3 Path Maintenance Data Link
Field Description
ffo present Use the command by itself to show the current setting
present Configure FFO alarm response
on Enable FFO alarm if fan faceplate is not present of is removed
off Disable FFO alarm (default)
Field Description
command name Type the command name for which you want to obtain help
? Displays the command and a list of its first level of parameters
help Displays the command and all its parameters if there is more than one
level of options