User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 8-45
CLI Commands and Messages
CLI Command List
EXIT
Name: Exit Session
Purpose: End the current session. The current user is logged out of the CLI. If security is on, a
user name (and password, if applicable) is required to log in again.
Security: ro and above
Syntax: exit
Example: exit
End the current session and log off from CLI.
FFO PRESENT
Name: Fan Faceplate Option Present
Purpose: Specify whether an alarm will be generated if the fan faceplate is not present or is
removed. The default is off.
Note: When an FFO-capable Controller is powered up or a fan faceplate is removed and
then reinstalled, the Controller will detect the fan faceplate and set ffo present on.
Security: Set - rw and above
Show - ro and above
Syntax: ffo present [on|off]
DS1/E1 Card Spare Active DS1/E1 card is installed and active, bu individual DS1/E1 circuits
may have failed
Not Present DS1/E1 card is not installed
MSO Active DS1/E1 MSO card (relay and electronics) is installed and active but
individual DS1/E1 circuits may have failed
MSO Relay Only
Spare Not Present
DS1/E1 MSO relay card is installed but electronics card is missing.
Circuits cannot be switched without spare electronics.
Conflict Multiple MSO card removals prevent switching circuits to Spare
Wrong Card for
Mode
System mode is set to DS1 when E1 card is installed, or vice versa.
Status applies to both MSO and non-MSO card types.
Equipment Status Description