User manual

CLI Commands and Messages
CLI Command List
8-44 July 2004 Wide Bank 28 DS3 - Release 2.4
Message:
Equipment Status
--------- ------
DS3 Controller A Active
DS3 Controller B Card not present
DS1 Card 1 Active
DS1 Card 2 Active
DS1 Card 3 Active
DS1 Card 4 Active
DS1 Card 5 Active
DS1 Card 6 Active
DS1 Card 7 Active
DS1 Spare Card Active
Equipment Status Description
DS3 Controller A/B Active Controller card is installed and in active mode (DS3 circuit is active)
Standby Controller is installed and in standby mode
Not Present Controller is not installed
Not Ready Controller is present but is not communicating with the active card
for unknown reasons
Fail Controller hardware failure
DS1/E1 Card Active DS1/E1 card is installed and active but individual DS1/E1 circuits
may have failed and be on Spare card
Not Present DS1/E1 card is not installed
MSO Active DS1/E1 MSO card (relay and electronics) is installed and active but
individual DS1/E1 circuits may have failed and be on Spare card
MSO Relay Only
Active on Spare
DS1/E1 MSO relay card is installed but electronics card is missing.
Circuits have been switched to Spare card.
MSO Relay Only
Not Active
DS1/E1 MSO relay card is installed but electronics card is missing.
Circuits have been switched to Spare card.
MSO Relay Only
Conflict On Spare
DS1/E1 MSO relay card is installed but electronics card is missing.
Multiple MSO card removals prevent switching circuits to Spare.
MSO Relay Only
Spare Not Present
DS1/E1 MSO relay card is installed but electronics card is missing.
Circuits cannot be switched because Spare card is not installed.
Wrong Card for
Mode
System mode is set to DS1 when E1 card is installed, or vice versa.
Status applies to both MSO and non-MSO card types.