User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 8-41
CLI Commands and Messages
CLI Command List
DS3 PORTNUMBER
Name: DS3 Port Number
Purpose: Set the DS3 Port Number to be sent on the C-bit parity link to the far end.
Security: rw and above
Syntax: ds3 portnumber {"string"}
Example: ds3 portnumber "25"
DS3 PROTECT
Name: DS3 Network Protection
Purpose: Configure DS3 network protection when using two DS3 lines. When DS3 protection is
enabled, the Wide Bank will switch to the standby Controller if the DS3 interface on
the active Controller has an alarm condition. The Wide Bank will not revert back to the
active Controller unless revertive switching is enabled (see REVERTIVE on
page 8-67).
Security: rw and above
Syntax: ds3 protect [off|on]
Example: ds3 protect on
Field Description
portnumber DS3 port number
"string" Alphanumeric string providing DS3 port number
Field Description
protect DS3 network protection
off Disable network protection (default). This setting will provide
electronics-only protection if there are two Controllers and only one
DS3 line.
on Enable network protection when there are two DS3 lines