User manual

CLI Commands and Messages
CLI Command List
8-40 July 2004 Wide Bank 28 DS3 - Release 2.4
Example: ds3 pm threshold
The following message shows the default values defined in GR-820-CORE.
Performance Thresholds: 15 min. 1 hour 1 day
-------- -------- --------
coding violations - line: 387 1161 3865
errored seconds - line: 25 75 250
coding viols-path p-bit: 382 1146 3820
err seconds - path p-bit: 25 75 250
loss of signal secs - line: 4 12 40
sev err seconds - line: 4 12 40
sev err sec - path cp-bit: 4 12 40
Example: ds3 pm threshold min15 cvl 32
Set PM threshold for CVLs to 32 for each 15-minute report interval.
cvp_p Code Violations - Path P-bit. The definition of CVP-P depends on the
particular DS3 application:
• For M23 applications, CVP-P is the number of P-bit parity check
Code Violations (CVs). The receipt of non-identical P-bits
corresponding to the same DS3 M-Frame also constitutes a parity
check CV.
• For C-bit applications, both CP-bit parity Code Violations (CVCP-
P) counts and CVP-P counts are defined and may be supported
because they can convey different information.
esp_p Errored Seconds - Path P-bit. The definition of CVP-P depends on the
particular DS3 application:
• For M23 applications, ESP-P is the number of one-second intervals
containing one or more P-bit parity errors, one or more Severely
Errored Frames (SEFs), or one or more AIS defects.
• For C-bit Parity applications, SSP-P is the number of one-second
intervals containing one or more ESP-P errors or ESCP-P errors.
ESCP-P is the number of seconds containing one or more CP-bit
parity violations, one or more Severely Errored Frames (ESFs), or
one or more AIS defects.
loss_l Loss of Signal Seconds - Line. The number of one-second intervals
containing one or more Loss of Signal (LOS) defects.
sesl Severely Errored Seconds - Line. The number of one-second intervals
in which Bipolar Violations (BPVs) plus Excessive Zeros (EXZs), or
one or more Loss of Signal (LOS) defects occur.
sescp_p Severely Errored Seconds - Path CP-bit. The number of one-second
intervals containing 44 or more C-bit Coding Violations (CCVs) OR
one or more Out of Frame defects OR a detected incoming AIS. This
count is only for the SYNTRAN and C-bit Parity DS3 applications.
Error Description