User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 8-31
CLI Commands and Messages
CLI Command List
Field Description
number Low-speed interface number, 1 to 28
range A range of low-speed channels separated by a hyphen as in 5-8
list A list of low-speed channels separated by commas as in 1,3,5,9
all All low-speed interfaces
send Send a code pattern (see settings below)
Setting Description
off Send no code or stop sending code
ais Send alarm indication signal (AIS) toward the low-speed side
cbit loopdown Send C-bit loopdown request toward the far-end low-speed
circuits on the DS3 network side using DS3 C-bit FEAC code
words. DS3 C-bit parity framing mode only
cbit loopup Send C-bit loopup request toward the far-end low-speed circuits
on the DS3 network side using DS3 C-bit FEAC code words.
DS3 C-bit parity framing mode only.
csu loopdown drop Send CSU loopdown code (100) toward the low-speed side and
wait for acknowledge
csu loopdown network Send a CSU loopdown code (100) over DS3 toward the far-end
low-speed circuit
csu loopup drop Send CSU loopup code (10000) toward the low-speed side and
wait for acknowledge
csu loopup network Send CSU loopup code (10000) over DS3 toward the far-end
low-speed circuit
niu loopdown drop Send NIU loopdown code request toward DS1 drop side
niu loopdown netowrk Send NIU loopdown code request over DS3 toward DS1 NIU at
remote end
niu loopup drop Send NIU loopup code request toward DS1 drop side
niu loopup network Send NIU loopup code request over DS3 toward DS1 NIU at
remote end
prbs drop Send unframed PRBS code toward the low-speed side. The
manager monitors the low-speed receive to detect PRBS errors
and will display the error count, error rate, and synchronization
state (sync/no sync).
prbs network Send unframed PRBS code toward the network side.
prbs test drop Perform Automated PRBS Test of DS1 drop side. The Wide
Bank will send an unframed PRBS code for 10 seconds and then
display the test result.