User manual

CLI Commands and Messages
CLI Command List
8-30 July 2004 Wide Bank 28 DS3 - Release 2.4
- DS1 5
Performance Thresholds: 15 min. 1 hour 1 day
-------- -------- --------
coding violations - line: 13340 40020 133400
errored seconds - line: 65 195 648
Example: ds1 1-4 pm threshold min15 cvl 32
Set DS1 circuits 1 to 4 for PM threshold CVLs to 32 for each 15-minute report interval.
DS1 PROTECT
Name: DS1 Protection
Purpose: Configure automatic low-speed electronics protection. The default is on.
Security: rw and above
Syntax: ds1 protect [on|off]
Example: ds1 protect on
Enable DS1 Electronics Protection.
DS1 SEND
Name: DS1 Send Code
Purpose: Configure low-speed circuit to send a code. This command permits a variety of bit
pattern codes to be sent toward the low-speed or network side. Each low-speed channel
includes a 2
15
–1 pseudo-random bit sequence (PRBS) code generator and detector (see
chapter 7).
Note: Because the codes are unframed, external test equipment may indicate a loss of
framing.
Security: rw and above
Syntax: ds1 {number|range|list|all} send setting
Field Description
protect Use the command by itself to show the current setting
on Enable low-speed electronics protection. This is the default.
off Disable low-speed electronics protection.