User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 8-27
CLI Commands and Messages
CLI Command List
DS1 LOOPDETECT
Name: DS1 Loopcode Detection
Purpose: Configure low-speed channel for detection of bit pattern loopcodes.
Security: rw and above
Syntax: ds1 {number|range|list|all} loopdetect {on|off|niu|cbit}
Example: ds1 11 loopdetect on
Set DS1 #11 to detect loopcodes.
DS1 METALLIC
Name: DS1 Metallic Loopback
Purpose: Configure metallic loopback toward low-speed side (see chapter 7). Metallic loopbacks
can only be applied to a maximum of four DS1 channels, one per protection group.
Security: rw and above
Field Description
number Low-speed interface number, 1 to 28
range A range of low-speed channels separated by a hyphen as in 5-8
list A list of low-speed channels separated by commas as in 1,3,5,9
all All low-speed interfaces
loopdetect Configure loopcode detection
on Enable loopcode detection
off Disable loopcode detection
niu Enable NIU loopcode detection only – turns off C-bit detection
cbit Enable C-bit loopcode detection only – turns off NIU detection