User manual

CLI Commands and Messages
CLI Command List
8-26 July 2004 Wide Bank 28 DS3 - Release 2.4
Example: ds1 9 line on
Apply DS1 #9 line loopback.
DS1 LINECODE
Name: DS1 Line Coding
Purpose: Configure line coding for low-speed circuits. DS1 circuits use AMI or B8ZS. E1
circuits are fixed at HDB3.
Security: rw and above
Syntax: ds1 {number|range|list|all} linecode {ami|b8zs}
Example: ds1 10 linecode b8zs
Set DS1 #10 for B8ZS line coding.
Field Description
number Low-speed interface number, 1 to 28
range A range of low-speed channels separated by a hyphen as in 5-8
list A list of low-speed channels separated by commas as in 1,3,5,9
all All low-speed interfaces
line Send line loopback toward low-speed side
on Apply line loopback
off Remove line loopback
Field Description
number Low-speed interface number, 1 to 28
range A range of low-speed channels separated by a hyphen as in 5-8
list A list of low-speed channels separated by commas as in 1,3,5,9
all All low-speed interfaces
linecode Configure DS1 line coding.
E1 circuits are fixed at hdb3 (High Density Bipolar 3).
ami Alternate Mark Inversion
b8zs Binary 8-Zero Substitution