User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 8-25
CLI Commands and Messages
CLI Command List
DS1 LENGTH
Name: DS1 Length for Line Buildout
Purpose: Adjust the DS1 line buildout (LBO) based on line length required for making cable
connections to DSX-1 crossconnect equipment. Not available for E1 circuits.
Security: rw and above
Syntax: ds1 {number|range|list|all} length
{dsx0|dsx110|dsx220|dsx330|dsx440|dsx550}
Example: ds1 5-8 length dsx220
Set DS1 #5 through #8 for line buildout of 330 to 440 feet.
DS1 LINE
Name: DS1 Line Loopback
Purpose: Configure line loopback toward low-speed side (see chapter 7).
Security: rw and above
Syntax: ds1 {number|range|list|all} line {on|off}
Field Description
number Low-speed interface number, 1 to 28
range A range of low-speed channels separated by a hyphen as in 5-8
list A list of low-speed channels separated by commas as in 1,3,5,9
all All low-speed interfaces
length Line buildout length (see settings below)
dsx0 Set for 0 to 110 feet
dsx110 Set for 110 to 220 feet
dsx220 Set for 220 to 330 feet
dsx330 Set for 330 to 440 feet
dsx440 Set for 440 to 550 feet
dsx550 Set for 550 to 660 feet