User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 8-23
CLI Commands and Messages
CLI Command List
Example: ds1 ains on
Enable automatic in-service detection of all low-speed channels that are subsequently
enabled.
Example: ds1 ains delay 12
Set automatic in-service delay to 12 hours.
DS1 CIRCUITID
Name: DS1 Circuit Identification
Purpose: Set the low-speed circuit identification string (transmission vendor’s identification),
which is used for SNMP display only.
Security: rw and above
Syntax: ds1 {number|range|list|all} circuitid {"string"}
Example: ds1 1 circuitid "DS1 1"
Set DS1 #1 circuit identifier.
DS1 ENABLE/DISABLE
CAUTION! DISABLING AN INTERFACE WILL DISRUPT SERVICE.
Name:
DS1/E1 Interface Enable/Disable
Purpose: Activate or deactivate a low-speed interface (normally used for SNMP managed
systems).
Security: rw and above
Field Description
number Low-speed interface number, 1 to 28
range A range of low-speed channels separated by a hyphen as in 5-8
list A list of low-speed channels separated by commas as in 1,3,5,9
all All low-speed interfaces
circuitid Set low-speed circuit identification string
"string" Alphanumeric string enclosed in quotes, as per RFC 1406
requirement for SNMP MIBs