User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 8-21
CLI Commands and Messages
CLI Command List
DS1
Name: DS1 Configuration Settings
Purpose: Show the DS1 or E1 low-speed interface configuration. The command followed by the
interface number displays the current configuration. (See following ds1 commands
with settings used to set the interface configuration.)
Note: When the LSMODE is set to DS1, you must use the DS1 commands. When the
LSMODE is set to either DS1LS or E1LS, you must use the LS commands. The LS
command operates just like the DS1 command, except that the responses are specific
to the DS1 or E1 interface type. In the DS1LS mode, the low-speed references in
command responses are the same as for the DS1 mode. In E1LS mode, the low-speed
references in command responses are for E1 (each E1 card has only three active
circuits; the fourth, unused, circuit on an E1 card is called CIR). See LSMODE on
page 8-58 and LS on page 8-50.
Security: ro and above
Syntax: ds1 {number|range|list|all}
Example: ds1 5
- 5
ds1 5 circuitid "DS1 5"
ds1 5 enable
ds1 5 equipment off
ds1 5 length dsx0
ds1 5 line off
ds1 5 linecode b8zs
ds1 5 loopdetect off
ds1 5 metallic off
ds1 5 send off
Performance Thresholds: 15 min. 1 hour 1 day
-------- -------- --------
coding violations - line: 0 0 0
errored seconds - line: 0 0 0
Example: ds1 all
Display configuration settings for all low-speed interfaces.
Field Description
number Low-speed interface number, 1 to 28
range A range of low-speed channels separated by a hyphen as in 5-8
list A list of low-speed channels separated by commas as in 1,3,5,9
all All low-speed interfaces