User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 8-19
CLI Commands and Messages
CLI Command List
Example: date 9/5/2002
Sets the date (month, day, and year) to September 5, 2002.
DAY
Name: Day Performance
Purpose: Show the 24-hour performance statistics for an interface. Display conforms to RFC
1406 and 1407 requirements for reporting SNMP MIB statistics.
For current hour statistics, see HOUR on page 8-47.
Security: ro and above
Syntax: day {ds3|ds3far|ds1 number}
Example: day ds3
15-Minute Interval Statistics for Near-end DS3 at 09:58:54 05/09/2001
STATISTIC \ INTERVAL Current 1 2 3 4 Day
--------------------- -------- -------- -------- -------- -------- ---------
Unavailable Sec 0 0 0 0 0 0
Loss of Signal Sec 0 0 0 0 0 0
P-Bit Sev Err Sec 0 0 0 0 0 0
P-Bit Errored Sec 0 0 0 0 0 0
Sev Err Framing Sec 0 0 0 0 0 0
Line Errored Sec 0 0 0 0 0 0
Line Sev Errored Sec 0 0 0 0 0 0
Protected Sec 0 0 0 0 0 0
Loopback Sec 0 0 0 0 0 0
PRBS Sync Sec 0 0 0 0 0 0
Protected Cnt 0 0 0 0 0 0
P-Parity Error Cnt 0 0 0 0 0 0
LCV Error Cnt 0 0 0 0 0 0
Elapsed Sec 834 LCV Error Rate 0
Valid Intervals 96 P-Parity Error Rate 0
FE Elapsed Sec N/A C-Parity Error Rate N/A
FE Valid Intervals N/A FE C-Parity Err Rate N/A
... FOLLOWED BY INTERVALS 5 THROUGH 96.
Field Description
day Show 24-hour statistics
ds1 number Display 24-hour performance statistics for selected DS1 interface
number, 1 to 28
ds3 Display 24-hour performance statistics for the DS3 interface
ds3far Display 24-hour performance statistics for the far-end DS3 interface.
(Valid only with C-bit framing.)