User manual

CLI Commands and Messages
CLI Command List
8-14 July 2004 Wide Bank 28 DS3 - Release 2.4
AUTOCOPY
Name: Automatic Copy Mode
Purpose: When turned on, allows the active Controller to automatically copy configuration
changes to the standby Controller. This command has no effect when only one
Controller is installed. Multi-user information is always copied between Controllers.
Security: Set - rw and above
Show - ro and above
Syntax: autocopy [on|off]
Example: autocopy on
Enables the autocopy mode.
CLEAR
Name: Clear Data
Purpose: Clears recorded statistics and logs.
NOTE: If you clear the event log, timestamps for any existing alarms or conditions are
also cleared.
Security: rw and above with basic security; admin and above for CLEAR ds1 and CLEAR ds3
with Security Upgrade; secu for CLEAR all, CLEAR log, CLEAR log standby, and
CLEAR wtr with Security Upgrade
See Security on page 1-5 for an overview of basic security and the Security Upgrade
option.
Syntax: clear {all|ds1 [number|range|all]|ds3|
log [standby]|wtr}
Setting Description
autocopy Use the command by itself to show the current setting
on Enables the active Controller to automatically copy configuration
changes to the standby Controller card
off Disables the autocopy mode
Field Description
all All interface statistics and log data
ds1 number Clear a low-speed interface number, 1 to 28
ds1 range Clear a range of low-speed interfaces separated by a hyphen as in 5-8