User manual

CLI Commands and Messages

CLI Command List

8-12 July 2004 Wide Bank 28 DS3 - Release 2.4

Security: Set - rw and above

Show - ro and above

Syntax: alarms standby {ds3_selftest|othercontrollerbad}

{critical|major|minor|na|nr}

Example: alarms standby ds3_selftest

Set to Not Reported

Indicates that standby Controller self-test failure alarm severity is currently set to Not

Reported (nr).

Example: alarms standby ds3_selftest minor

Set to Minor

Sets standby Controller self-test failure alarm severity to Minor.

Example: alarms standby ds3_selftest major

Notice: Limited to Minor by Active Setting

Set to Major

Sets standby Controller self-test failure alarm severity to Major. However, the

accompanying “Notice” indicates that this alarm severity will be limited to Minor

because the active Controller alarm severity is currently set to Minor. The standby

Controller alarm severity can be no higher than the active Controller setting.

Field Description

ds3_selftest

Standby DS3 Controller failed Self-Test

othercontrollerbad

Active DS3 Controller lost communications with the

standby Controller

critical

Set alarm condition level to Critical

major

Set alarm condition level to Major

minor

Set alarm condition level to Minor

Not Alarmed. Condition is logged and reported as an

event (REPT EVT) instead of an alarm (REPT ALM).

Not Reported. Condition is logged but not reported.