User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 8-7
CLI Commands and Messages
Command Line Interface
Context Sensitive Help
The Command Line interface has a context-sensitive help feature that tells you what the command
options are. If you type a question mark (?) at the prompt by itself, the entire list of commands is
displayed. If you type a question mark after the name of a command, the first-level options for that
specific command are displayed. Some commands have more options under the first level, which
can be displayed only by typing
help after the name of the specific command.
For example, note that the first command (ds1 ?) below shows the first level of options, and the
second command (ds1 help) below shows all option for the ds1 command.
Example: Show First level of options for the ds1 command.
(A:Active)> ds1 ?
ds1 [n|range|all] .............. Set/Display DS1 n=1..28, range=x-y or all
circuitid "id" ............. DS1 Circuit ID
enable/disable ............. Activate/Deactivate DS1 Interface
equipment .................. Apply DS1 Equipment Loopback
length ..................... Set DS1 line length
line ....................... Apply Line Loopback to DS1
linecode ................... Coding Type
loopdetect ................. Set Detection of Loop Codes
metallic ................... Apply DS1 Metallic Loopback
move ....................... Move Control of DS1 n to Spare DS1
pm threshold ............... Show/Set DS1 PM Threshold Values
send ....................... Send a Code on DS1 Toward Drop or Network
Example: Show all levels of options for the ds1 command.
(A:Active)> ds1 help
ds1 [n|range|all] .............. Set/Display DS1 n=1..28, range=x-y or all
circuitid "id" ............. DS1 Circuit ID
enable/disable ............. Activate/Deactivate DS1 Interface
equipment .................. Apply DS1 Equipment Loopback
off .................... Disable DS1 equipment loopback towards DS3
on ..................... Enable DS1 equipment loopback towards DS3
length ..................... Set DS1 line length
dsx0 ................... DSX (0'-110')
dsx110 ................. DSX (110'-220')
dsx220 ................. DSX (220'-330')
dsx330 ................. DSX (330'-440')
dsx440 ................. DSX (440'-550')
dsx550 ................. DSX (550'-660')
line ....................... Apply Line Loopback to DS1
off .................... Disable DS1 Line Loopback towards DS1
on ..................... Enable DS1 Line Loopback towards DS1