User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 7-29
Diagnostics & Troubleshooting
Testing Low-Speed Interface Operation
Running Maintenance Tests on a Low-Speed Circuit
NOTE: When the lsmode mode is set to either ds1ls or e1ls, the ds1 command becomes
the ls command. The operation of the ls command is identical to the ds1 command, except
the references to the circuits are changed to either LS, DS1, or E1. See Chapter 8 for
description
This test is used to test the low-speed circuits using the redundant low-speed circuits.
1. Move low-speed circuit #5 to the spare group and display protection
(A:Active)> ds1 5 move spare
(A:Active)> status ds1 all
Interface Receive Transmit Loop Protection
--------- ------- -------- ---- ----------
DS1 1 Traffic Traffic None 1 used by DS1 5
DS1 2 Traffic Traffic None by Spare 2
DS1 3 Traffic Traffic None by Spare 3
DS1 4 Traffic Traffic None by Spare 4
DS1 5 Traffic Traffic None 1 used by DS1 5
DS1 6 Traffic Traffic None by Spare 2
DS1 7 Traffic Traffic None by Spare 3
DS1 8 Traffic Traffic None by Spare 4
DS1 9 Traffic Traffic None 1 used by DS1 5
DS1 10 Traffic Traffic None by Spare 2
DS1 11 Traffic Traffic None by Spare 3
DS1 12 Traffic Traffic None by Spare 4
DS1 13 Traffic Traffic None 1 used by DS1 5
DS1 14 Traffic Traffic None by Spare 2
DS1 15 Traffic Traffic None by Spare 3
DS1 16 Traffic Traffic None by Spare 4
DS1 17 Traffic Traffic None 1 used by DS1 5
DS1 18 Traffic Traffic None by Spare 2
DS1 19 Traffic Traffic None by Spare 3
DS1 20 Traffic Traffic None by Spare 4
DS1 21 Traffic Traffic None 1 used by DS1 5
DS1 22 Traffic Traffic None by Spare 2
DS1 23 Traffic Traffic None by Spare 3
DS1 24 Traffic Traffic None by Spare 4
DS1 25 Traffic Traffic None 1 used by DS1 5
DS1 26 Traffic Traffic None by Spare 2
DS1 27 Traffic Traffic None by Spare 3
DS1 28 Traffic Traffic None by Spare 4
Spare 1 Available
Spare 2 Available
Spare 3 Available
Spare 4 Available