User manual

Configuration
Downloading New Software
6-36 July 2004 Wide Bank 28 DS3 - Release 2.4
NOTE: A prompt asks if you want to program the FLASH now. If you say no, you will
have to do it later, using a program flash command. Until you program FLASH your Wide
Bank is still running the old firmware.
Do you want to Program the FLASH now (Y/N)?
3. Enter Y.
NOTE: Because there is no secondary (backup) Controller, the following message
appears. It warns that an interruption of traffic (up to 90 seconds) will occur.
WARNING: Secondary Controller is not present
Programming the FLASH will cause interruption of traffic.
Do you want to Program the FLASH now (Y/N) ?
4. Enter Y.
Please wait until this controller comes alive (Approximately 1
min.)
Firmware upgrade in process...
Erasing Flash. Please wait...
Programming Flash. Please wait...
Programming Successful.
The system now resets, during which the DS3 traffic is interrupted for up to 90 seconds.
NOTE: If you are using a Telnet session for this download, you will have to re-establish
the Telnet session after the reset.