User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 6-35
Configuration
Downloading New Software
8. Do you want to Program the FLASH now (Y/N)?
9. Enter Y.
NOTE: Because there is no secondary (backup) Controller, the following message
appears. It warns that an interruption of traffic (up to 90 seconds) will occur.
WARNING: Secondary Controller is not present
Programming the FLASH will cause interruption of traffic.
Do you want to Program the FLASH now (y/n)?
10.Enter Y.
Please wait until this controller comes alive (Approximately 1
min.)
Firmware upgrade in process...
Erasing Flash. Please wait...
Programming Flash. Please wait...
Programming Successful.
The system will now reset, during which the DS3 traffic is interrupted for up to 90 seconds.
TFTP Download Initiated Via RS-232 or Ethernet
This procedure applies when you are using TFTP to download, invoked either through the RS-
232 port or by Telnet session through the Ethernet port. Connect a PC or terminal as described
in Management Connections for Downloading Firmware on page 6-23
NOTE: Make sure there are no existing error or alarm conditions on the unit before you
proceed.
1. Log in to the Wide Bank.
2. At the prompt, enter the load command, as follows (Be sure to include the quotes in the
filename, and give the complete path):
(A:Active)> load tftp [TFTP server IP address] "[filename]"
Initializing memory buffer...
Downloading Image using TFTP. Please wait...
TFTP Download Finished
Verifying. Please wait...
Verification Successful