User manual

Configuration
Downloading New Software
6-32 July 2004 Wide Bank 28 DS3 - Release 2.4
Downloading to a Non-Redundant Wide Bank 28 DS3
Connect a PC or terminal as described in Management Connections for Downloading Firmware on
page 6-23
 Xmodem Download Initiated Via RS-232 ... 6-32
 TFTP Download Initiated Via RS-232 or Ethernet ... 6-35
NOTE: Make sure there are no existing error or alarm conditions on the unit before you
proceed.
Xmodem Download Initiated Via RS-232
The following procedure assumes you are using MS HyperTerminal to perform the download.
NOTE: When the CLI is in E1LS mode, the following low-speed circuit references are
changed to E1 instead of DS1.
1. Log in as usual:
16:51:49 01/01/1997
Automatic Login to Controller Card A
Equipment Status
--------- ------
DS3 Controller A Active
DS3 Controller B Card not present
DS1 Card 1 Active
DS1 Card 2 Active
DS1 Card 3 Active
DS1 Card 4 Active
DS1 Card 5 Active
DS1 Card 6 Active
DS1 Card 7 Active
DS1 Spare Card Active
(A:Active)>