User manual

Configuration
Basic Configuration
6-22 July 2004 Wide Bank 28 DS3 - Release 2.4
Verifying Autocopy to Secondary Controller
With a secondary Controller card installed, and the autocopy feature on (default), the secondary
Controller will automatically reflect the same configuration as the primary Controller. The only
way to verify that autocopy worked is to switch Controllers and check configurations. If
autocopy is off (autocopy off), or if you choose to manually copy the configuration, the
configuration can be copied to the secondary Controller with a copy command. There may be
some cases (in protected DS3 installations) when the primary and secondary Controller/DS3
interfaces will not have the same configuration. In these cases, autocopy should be turned off
(use the command autocopy off).
NOTE: The security configuration (user names, access levels, passwords) is always
autocopied between Controllers.
Turning Off Unused or Unterminated Low-Speed Channels
For continued FCC Part 15A and NEBS compliance, unused and unterminated low-speed channels
must be turned off by issuing the CLI ds1 or ls command:
(A:Active)> ds1 [n|range|all] disable
or
(A:Active)> ls [n|range|all] disable
Logging Off
When you have finished configuring the Wide Bank, you can log off with the exit command.
(A:Active)> exit
Logging out