User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 6-19
Configuration
Basic Configuration
Configuring Low-Speed Ports
There are two forms of DS1 line coding supported on the Wide Bank: B8ZS and AMI. You can
configure to either form, as shown below using AMI as an example.
NOTE: There is only one line-coding for E1: HDB3. When E1 cards are installed in the
Wide Bank 28 DS3 and the CLI is set for E1LS mode (see the lsmode command), the
following DS1 references are changed to E1.
(A:Active)> ds1 5
The DS1 channel # is: 5
For example, to configure DS1 interface 5 to AMI line coding:
(A:Active)> ds1 5 linecode ami
The DS1 channel # is: 5
ds1 5 linecode ami
Saving the Configuration
There is no need to manually save the configuration. The Wide Bank retains the working
configuration settings in non-volatile storage. If power is lost and regained, the working
configuration is always retained.
NOTE: An additional backup of the configuration can be sent to a user file using a save
tftp command.
NOTE: When E1 cards are installed in the Wide Bank and the CLI is set for E1LS mode,
the following DS1 references are changed to E1.
Table 6-3 CLI Low-Speed Displays for Different LS Modes
CLI in DS1 or DS1LS Mode
Low-Speed Mode is DS1 ("ds1" commands) or
Low-Speed Mode is DS1 ("ls" commands)
CLI in E1LS Mode
Low-Speed Mode is E1 ("ls" commands)
- DS1 5
ds1 5 circuitid "DS1 5"
ds1 5 enable
ds1 5 equipment off
ds1 5 length dsx0
ds1 5 line off
ds1 5 linecode ami
ds3 5 loopdetect off
ds1 5 metallic off
ds1 5 send off
- LS Circuit 5
e1 13 circuitid "E1 5"
e1 13 enable
e1 13 equipment off
e1 13 line off
e1 13 loopdetect off
e1 13 metallic off
e1 13 send off