User manual

Configuration
Basic Configuration
6-16 July 2004 Wide Bank 28 DS3 - Release 2.4
(A:Active)> ip nms3 192.168.0.5
(Third IP Address for SNMP Trap notification)
(A:Active)> ip ppp 192.168.0.6
(IP Address for far end of the PPP link - DS3 C-bit framing
only)
(A:Active)> ip route ethernet
(Set route for outbound IP traffic: ppp or ethernet. Ethernet
is the default. DS3 C-bit framing is only for ppp route.)
Verify Network Settings
(A:Active)> ip
ip address 192.168.0.5
ip mask 255.255.255.0
ip gateway 192.168.0.1
ip nms1 192.168.0.3
ip nms2 192.168.0.4
ip nms3 192.168.0.5
ip ppp 192.168.0.6
ip route ethernet
Figure 6-2 IP Routing with Point-to-Point Protocol
Wide Bank 28 DS3
(Near End)
Ethernet
IP over PPP
over DS3 data link
Remote unit Configuration Requirements:
ip route ppp
Local unit Configuration Requirements:
ip ppp ipaddr = Remote unit IP address
ip route ethernet
Wide Bank 28 DS3
(Far End)
Local
Remote