User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 6-15
Configuration
Basic Configuration
Disable SNMP Management (Security Upgrade Option)
(A:Active)> security snmp disable
SNMP feature disabled
Disable TL1 Management (Security Upgrade Option)
(A:Active)> security tl1 disable
TL1 feature disabled
Configuring IP and PPP Addresses
The Wide Bank includes SNMP and Telnet support. Before they can be used, the following network
settings must be configured. These settings are not necessary if you do not want to use SNMP or
Telnet.
The following example represents a response while in C-bit framing mode. If the Wide Bank is not
in C-bit framing mode, the ip ppp and ip route ppp|ethernet items are not available.
(A:Active)> ip
ip address 192.168.2.40
ip mask 255.255.255.0
ip gateway 192.168.2.202
ip nms1 192.168.0.4
ip nms2 206.168.118.70
ip nms3
ip ppp 192.168.5.10
ip route ethernet
(A:Active)> ip address 192.168.0.5
Modifying IP address will affect ability to remotely manage this unit.
The IP address for remote management will be 192.168.0.5
Do you want to update the IP address now (y/n)?
(First IP Address of the active controller)
(A:Active)> ip mask 255.255.255.0
(Subnet mask for LAN)
(A:Active)> ip gateway 192.168.0.1
(IP Address for the LAN gateway)
(A:Active)> ip nms1 192.168.0.3
(IP Address for SNMP Trap notification)
(A:Active)> ip nms2 192.168.0.4
(Second IP Address for SNMP Trap notification)