User manual

Configuration
Basic Configuration
6-14 July 2004 Wide Bank 28 DS3 - Release 2.4
Show Current User Settings (Security Upgrade Option)
(A:Active)> user
User Level Last Login
---- ----- ----------
security secu 11:39:36 06/23/2004 (Active)
john admin 11:39:36 06/23/2004
bill rw 11:02:52 06/23/2004
marie rw Never logged in
jack ro Never logged in
morgan ro 11:39:14 06/23/2004
When security is on, the currently logged-on user is indicated as (Active).
Set CLI Time-Out (Security Upgrade Option)
(A:Active)> security cli 30
CLI timeout = 30 minutes
Disable Ethernet Port (Security Upgrade Option)
(A:Active)> security ethernet disable
Disabling this port will affect the ability to remotely
manage this unit. It will not be possible to remotely
manage this unit on IP Address nnn.nnn.nnn.nnn
Do you want to disable the Ethernet port now (y/n)?
nnn.nnn.nnn.nnn is the Wide Bank’s IP address. Remote management will no longer be
possible over this address.
Disable 9-Pin RS-232 CLI Port (Security Upgrade Option)
(A:Active)> security rs232cli disable
Disabling this port will disable the ability to locally
manage this unit. Remote management will be possible on
IP Address nnn.nnn.nnn.nnn
Do you want to disable the CLI port now (y/n)?
nnn.nnn.nnn.nnn is the Wide Bank’s IP address. Before disabling the CLI port, you must assign
a valid IP address. See Configuring IP and PPP Addresses on page 6-15.
Disable 25-Pin RS-232 TL1 Port (Security Upgrade Option)
(A:Active)> security rs232tl1 disable
TL1 RS-232 port disabled