User manual

Configuration
Basic Configuration
6-6 July 2004 Wide Bank 28 DS3 - Release 2.4
Restoring Factory Defaults
The working configuration can be replaced with the original factory defaults by using the restore
defaults command. Both the working configuration and the factory defaults are stored in non-
volatile storage and are retained when power is turned off.
One use for the restore defaults command is to re-configure the Wide Bank when the working
configuration is lost or corrupted and there is no temporary copy to restore.
To restore the configuration to the factory default settings, enter the following command.
(A:Active)> restore defaults
Factory default settings are now restored.
Validating Equipment
Validate that all the required interfaces are present. The equipment command lists all the low-speed
and DS3 cards and shows their status. If the LS mode does not match the card type that is installed,
comments in the low-speed status will say “Wrong card for LS mode.”
Table 6-2 CLI Equipment Displays for Different LS Modes
CLI in DS1 or DS1LS Mode
Low-Speed Mode is DS1 ("ds1" commands) or
Low-Speed Mode is DS1 ("ls" commands)
CLI in E1LS Mode
Low-Speed Mode is E1 ("ls" commands)
(A:Active)> equipment
Equipment Status
--------- ------
DS3 Controller A Active
DS3 Controller B Standby
DS1 Card 1 Active
DS1 Card 2 Active
DS1 Card 3 MSO Active
DS1 Card 4 Active
DS1 Card 5 Active
DS1 Card 6 Active
DS1 Card 7 Active
DS1 Spare Card Card not present
(A:Active)> equipment
Equipment Status
--------- ------
DS3 Controller A Active
DS3 Controller B Standby
E1 Card 1 Active
E1 Card 2 Active
E1 Card 3 MSO Active
E1 Card 4 Active
E1 Card 5 Active
E1 Card 6 Active
E1 Card 7 Active
E1 Spare Card Card not present