User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 5-11
Electrical Installation and Cabling
Management Cables
TL1 RS-232 Port Cable
Connect a shielded DB25 cable between the Wide Bank’s TL1 RS-232 asynchronous port and
either a terminal multiplexer or an external X.25 pad to provide asynchronous RS-232 to X.25
conversion if preferred.See TL1 RS-232 Management Port Pinout on page A-8.
Ethernet Management Port
Connect an Ethernet cable between the Wide Bank’s Ethernet port and an IP network for remote
management using SNMP, Telnet, TL1 alarms, and Carrier Access’ NetworkValet EMS software.
The Wide Bank’s Ethernet port accepts a standard RJ-45 connector. See Ethernet RJ-45 (10Base-
T) Pinout on page A-9. The Ethernet cable must be shielded for compliance with NEBS and FCC
requirements.
NOTE: For remote management over an IP network, you must know the IP address of
the Wide Bank (see Configuring IP and PPP Addresses on page 6-15). For TL1 the default
TCP port number is 9999 but this can be changed (see TL1 Setup and Configuration on
page 9-9).
Figure 5-9 Connecting to Ethernet Port for Remote Management
TL1 RS-232 PortEthernet Port
CLI RS-232 Port
RS-232 (COM) Port
Ethernet
PC with
Management
Software
Ethernet Port