User's Manual

Wi-linktech Communication Technologies (Shanghai) Co.,Ltd.
RF
exposure considerations
This
equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment .This equipment should be installed and
operated with minimum distance 20cm between the radiator& your body.
If the device built into a host as a portable usage， the additional
RF exposure evaluation may be required as specified by 2.1093.
Antennas
This module using PCB antennas with maximum gain is 3 dBi .
Label and compliance information
The outside of final products that contains this module device
must display a label referring to the enclosed module. This exterior
label can use wording such as:"Contains Transmitter Module FCC ID:
2AOO6-WLT8258 " ， Any similar wording that expresses the same
meaning may be used.
Information on test modes and additional testing requirements
a) The modular transmitter has been fully tested by the module
grantee on the required number of channels， modulation types， and modes，
it should not be necessary for the host installer to re-test all the
available transmitter modes or settings. It is recommended that the host
product manufacturer， installing the modular transmitter， perform some
investigative measurements to confirm that the resulting composite system
does not exceed the spurious emissions limits or band edge limits (e.g.，
where a different antenna may be causing additional emissions).
b) The testing should check for emissions that may occur due to the
intermixing of emissions with the other transmitters， digital circuitry，
or due to physical properties of the host product (enclosure). This
2019.03
www .w i - li nk te ch .c om
17