Specifications

Table Of Contents

Wi-linktechCommunicationTechnologies(Shanghai)Co.,Ltd

conditions it might be appropriate touse a technology-specific call box

(test set) where accessory devices or drivers are not available.

When testing for emissions from the unintentional radiator， the

transmitter shall be placed in the receive mode or idle mode， if possible.

If receive mode only is not possible then， the radio shall be passive

(preferred) and/or active scanning. In these cases ， this would need to

enable activity on the communication BUS (i.e.， PCIe， SDIO， USB) to

ensure the unintentionalradiator circuitry is enabled. Testing

laboratories may need to add attenuation or filters depending on the

signal strength of any active beacons (if applicable) from the enabled

radio(s). See ANSI C63.4， ANSI C63.10 and ANSI C63.26 for further general

testing details.

The product under test is placed into a normal ‘paired' mode with

another BLE device， as per the normal intended use of the product (for

example， transferring data).

FCC Statement

Any Changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate the

equipment. This device complies with part 15 of the FCC Rules. Operation

is subject to the following two conditions: (1) This device may not

cause harmful interference， and (2) This device must accept any

interference received, including interference that may cause

undesired operation.

2019.09

www