User's Manual

 BUILT-IN CABINET INSTRUCTIONS

These appliances are designed for both built-in or free standing installation. If you plan to use the

appliances in a built-in application please follow the requirements shown below.

Cabinet Opening Dimensions (min)

BWR-18SD

BWR-33SD

Width

12” / 30 cm

15” / 38 cm

Depth

23¼” / 59 cm

Height

34¼” / 87 cm

 ELECTRICAL CONNECTION

This appliance requires a standard 115/120 Volt AC ~/60Hz electrical ground outlet with three-prong.

Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly

grounded. The cord should be secured behind the appliance and not left exposed or dangling to

prevent accidental injury.

The appliance should always be plugged into its own individual electrical outlet which has a voltage rating

that matches the rating label on the appliance. This provides the best performance and also prevent

overloading house wiring circuits that could cause a fire hazard from overheated. Never unplug the

appliance by pulling the power cord. Always grip the plug firmly and pull straight out from the receptacle.

Repair or replace immediately all power cords that have become frayed or otherwise damaged. Do not

use a cord that shows cracks or abrasion damage along its length or at either end. When moving the

appliance, be careful not to damage the power cord.

 EXTENSION CORD

Because of potential safety hazards, it is strongly recommended that you do not use an extension cord

with this appliance. However, if you must use an extension cord it is absolutely necessary that it be a

UL/CUL-Listed, 3-wire grounding type appliance extension cord having a grounding type plug and outlet

and that the electrical rating of the cord be 115 volts and at least 10 amperes.

WARNING

Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is

damaged, have it replaced by a qualified electrician or an authorized service center.