User's Manual

 STORAGE

Wine bottles may differ in size and dimensions so the actual number of bottles can be stored may vary.

The 18 or 33 bottle capacities are approximate maximums when storing traditional Bordeaux 750 ML

bottles and includes bulk storage.

NOTE: Wine bottles on bottom shelf cannot be longer than 12 inches.

 DOOR LOCK

The appliance is provided with a lock and key combination.

The keys are located inside the plastic bag that holds the Owner’s Manual. Insert the key into the lock and

turn it counterclockwise to unlock the door. To lock the door do the reverse operation making sure metal

pin is engaged completely. Remove the key and place it in a secure place..

 WINE SHELVES

To prevent damaging the door gasket, make sure to have the door all the way opened when pulling the

shelves out of the rail compartment.

 For easy access to the storage content, you must

pull the shelf approximately ⅓ out of the rail

compartment, however this appliance is designed

with a plastic post on each sides of the shelf track

to prevent the shelves and the bottles from

completely sliding out or falling.

 When removing the shelves out of the inner rail,

make sure to remove all items first. Then move the

shelf to the position where the notch of shelf is

exactly under the plastic post and lift the shelf. In order to replace the shelves, repeat steps described

above in reverse.

 HUMIDITY CONTROL

 This appliance is equipped with a system for maintaining the correct level of humidity. Fill the small

plastic reservoir (humidity box) to about ¾ full with water, the place it onto the runners found on the

top shelf of the appliance. Check the water level

regularly and reﬁll as necessary.

 Please ensure the reservoir is positioned correctly on

the runners on the top shelf to avoid the possibility of

water spillage.

 ACTIVE CHARCOAL FILTER

Replace the active charcoal filter with new one once a year. It can be purchased from the retailer or

Whynter’s Service Department.

To change the filter,

 Turn the filter cover 90°clockwise or anti-clockwise. And then

remove the filter.

 Insert the new filter in the vertical position.

 Turn the filter cover 90° clockwise or anti-clockwise until it click

into position.