Whynter Countertop Direct Connection Ice Maker and Water Dispenser - Silver Model # : IDC-221SC INSTRUCTION MANUAL Congratulations on your new Whynter product. To ensure proper operation, please read this Instruction Manual carefully before using this product. Keep this manual in a safe place for future reference.
DISPOSAL INFORMATION Thank you for choosing the Whynter Countertop Direct Connection Ice Maker and Water Dispenser. Please follow the instructions provided in this user guide to obtain the very best performance from your Ice Maker and Water Dispenser. We trust that your Whynter Ice Maker and Water Dispenser will provide the performance and reliability that we stand for. Please keep this user manual in a safe place for future reference.
TABLE OF CONTENTS / TECHNICAL SPECIFICATIONS TABLE OF CONTENTS DISPOSAL INFORMATION 2 TECHNICAL INFORMATION 3 SAFETY PRECAUTIONS 4 PARTS AND CONTROL PANEL 5 LCD DISPLAY OVERVIEW 6 INSTALLATION AND OPERATING INSTRUCTIONS 7–8 CARE AND MAINTENANCE 9 TROUBLESHOOTING 10 WARRANTY INFORMATION 11 TECHNICAL SPECIFICATIONS MODEL : Power Consumption: IDC-221SC 165W Power Supply: 115V/ 60Hz Water Reservoir Capacity: 2.0L Ice Making Current: 1.
SAFETY PRECAUTIONS WARNING TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY WHEN USING YOUR ICE AND WATER DISPENSER, FOLLOW THESE BASIC PRECAUTIONS: Read all instructions before using the appliance Never clean appliance parts with flammable fluids. The fumes can create a fire hazard.
PARTS AND CONTROL PANEL 1.a 1.b 1 5 6 9 4 7 2 3 8 1 4.a 4.b 4.c 4.d 12 10 Ice Bin Access Lid 1.a Ice Full Sensor 1.b Ice Shovel 2 Water Inlet Port 3 Power Cord 4 Water Reservoir Access Door 4.a Ice Reservoir Drain Outlet 4.b Water Inlet Supply 4.c Water Level Sensor 4.d Water Reservoir 5 LCD Display 6 Control Panel 7 Water and Ice Dispenser Outlet 8 Water Drip Tray 9 Air Vent 10 Drain cap and Rubber Drain Plug 11 Rubber Grip Legs (4) 12 12 ft.
LCD DISPLAY OVERVIEW 1 2 3 4 5.a 5.b 5.c 6 7 10 9 8 11 1. TIMER INDICATOR Displays remaining time when unit to turn ON or OFF. (see Timer Setting Instructions on page 8) 5.b WATER INDICATOR When the water indicator is solid, the unit is pumping water to make ice. If the water level is too low, the indicator will flash and the unit will stop working automatically. Once you add water to the unit, the indicator will turn off and the unit will resume normal operation. 5.
INSTALLATION AND OPERATING INSTRUCTIONS INSTALLATION OF YOUR ICE MAKER AND WATER DISPENSER This unit should be installed by a licensed plumber only (DIRECT WATER CONNECTION METHOD only) Before connecting the unit to the power source, let it stand upright for approximately 4 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. Place the unit away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
INSTALLATION AND OPERATING INSTRUCTIONS ICE MAKING INSTRUCTIONS 1. Turn the unit on by pressing the Power button. 2. Select desired ice size by pressing the ice size selector button (Small or Large). 3. Water will be pumped from the water reservoir to the water tray under the freezing bars. The freezing bars will start freezing. Once the freezing process is complete, the freezing bars will heat up to drop the ice and the ice shovel will push the ice down to the ice storage bin. 4.
INSTALLATION AND OPERATING INSTRUCTIONS TIMER SETTING INSTRUCTIONS TIMER DELAY SWITCH ON When the unit is OFF, press the Timer button on the control panel and the time indicator will flash. Set the desired time delay ON hours by pressing the Select button. The time increments are 0.5 hour up to 18 hours. The time displayed will change invariably and will decrease by 0.1 Hr. When the delay time set has elapsed, the unit will turn on.
CARE AND MAINTENANCE CAUTION : Failure to unplug the unit could result in electrical shock or personal injury Periodic cleaning and proper maintenance will ensure efficiency, top performance, and long life. The maintenance intervals listed are based on normal conditions. Regularly inspect plumbing connections to insure that no leaks are present. Disconnect the water inlet hose if the unit will not be used for a long period of time. Never keep anything in the ice storage bin that is not ice.
TROUBLESHOOTING Problem Water leaking from the back of the unit Possible Causes Solutions Water inlet hose not properly inserted Insert the inlet hose properly into the water inlet port Water pressure is too high The recommended water pressure is 58 PSI.
ONE YEAR LIMITED WARRANTY This Whynter Ice Maker and Water Dispenser is warranted, to the original owner within the 48 continental states, for one year from the date of purchase against defects in material and workmanship under normal use and service. When making a warranty claim, please have the original bill or invoice of purchase with purchase date available.
