User manual

INSTALLATION

LOCATION

The air conditioner should be placed on a hard and level surface strong enough to support the unit. The unit has

casters and it should only be rolled on smooth, flat surfaces. Use caution when rolling on carpet surfaces. Do not

attempt to roll the unit over objects. Never place any obstacles around the air inlet or outlet and allow at least 20" of

clearance for efficient air-conditioning.

EXHAUST HOSE INSTALLATION

When using the air conditioner in COOL mode, hot air

must be exhausted out of the room to complete the air

exchange of the condenser. When the unit is operating

in DRY or FAN only mode, installation of the exhaust

hose is optional.

1. Snap the hose connector to the unit onto one end of

the hose and then snap the hose connector to the

window onto the other end. See Fig. 1

2. Line-up the hose connector hooks onto the back of

the unit and slide into the hole seat. See Fig. 2

3. Only extend the exhaust hose to the necessary

length keeping it as short and straight as possible.

WINDOW KIT INSTALLATION

The window kit has been designed to fit most standard vertical and horizontal windows. However, it may be

necessary to modify the installation procedures to accommodate your window. Please refer to Fig. 3a and Fig. 3b

for minimum and maximum window openings. If your window opening is less than the mentioned minimum length

of the window slider kit, the window slider kit can be cut to fit the window opening. Never cut into the exhaust hose

cut-out on the window slider kit.

If your window opening is larger than the maximum length of the window slider kit, additional material will be

needed to cover the open space such as, Plexiglas, PVC plastic, ply wood, etc. Alternately, an additional window

slider kit can be purchased to be used in combination with the included kit.

NOTE: When using the window slider kit on a window or sliding door, additional security measures may be

needed.

The window slide bars can be fixed with the clear plastic bolt. Fig. 4.

Fig. 3a Fig. 4

Fig. 3b

Fig. 1

Fig. 2

Hook

Hole Seat

Clear plastic

plug