Instructions/Assembly Guide

e Page 
f
&RQWURO3DQHO
%FIVNJEJGZ.PEF
*OUIJTNPEFUIFBJSDPOEJUJPOFSPOMZEFIVNJEJGJFTUIFSPPNUIFDPNQSFTTPSXJMMBDUJWBUFJOUFSNJUUFOUMZEFQFOEJOHPOUIF
BNCJFOUUFNQFSBUVSFBOEUIFGBOTQFFEJTTFUUP-085PBDUJWBUFUIJTGVODUJPONPEFQSFTTUIF.0%&CVUUPOVOUJMUIF%3:
JOEJDBUPSMJHIUJTEJTQMBZFE1MFBTFOPUFUIBUXIFOTXJUDIJOHGVODUJPONPEFUIFSFXJMMCFBOBQQSPYJNBUFMZNJOVUFUSBOTJUJPO
UJNF*OEFIVNJEJGZJOHNPEFUIFFYIBVTUIPTFEPFTOPUOFFEUPCFWFOUFE*GUIFFYIBVTUIPTFJTWFOUFEUIFSPPNXJMMCF
cooled as it dehumidifies. To prevent cooling, remove the exhaust hose from the window kit and allow the warm air from the
rear to be re-circulated into the room. If room temperature is higher than 77°F, the fan speed can be adjusted. If room
temperature is lower than 77°F, the fan speed is set at Low.Note: When using dehumidifying mode, venting the exhaust hose to the
outside is not required. If vented, the warm air is exhausted to the outside and cooling within the room may occur. If the exhaust hose is
not vented, the unit may require more frequent draining. Additionally, the air conditioner does not have a humidistat in which a
specific humidity level can be set.
Fan Mode
In this mode, only the fan of the air conditioner runs and circulates the air in the room. To activate this function mode, press the
MODE button until the FAN indicator light comes on. In this function mode, the temperature cannot be set.
Note : Unit does not need to be vented in Fan mode
Filter Timer
After 250 hours of operation, the indicator light will glow to remind you to clean the filter. Remove the filter and clean it. Note :
After switching the air conditioner off, you must wait 3 minutes before switching it back.
5BOL'VMM
If the internal tank becomes full, the Tank Full indicator will illuminate and the unit will not operate until the unit has been
drained.