Instructions/Assembly Guide

e Page 

&RQWURO3DQHO

Swing Control

The SWING button moves the air louver, evenly distributing the air into the room. When the SWING button is pressed, the flap

will begin to move forwards and backwards alternatively. If pressed again, the flap will be locked into its current position. When

the button is next pressed, the flap will start to move forwards and backwards again.

NOTE: In order to avoid damaging the internal mechanisms, the flap must not be moved manually.

Mode Control

Press to change modes. Controls the 4 function modes: COOL, FAN, HEAT and DRY.

Lamp On/Off Control

Press to turn on or off the front and top panel lights.

Timer

Auto turn off and on

With the air conditioner operating in any function mode, press the TIMER button. The TIMER light will come on. Set the desired

time delay OFF or ON hours by pressing the UP and DOWN buttons. The time increments are by 1 hour increment up to 24

hours. When the delay time set has elapsed, the air conditioner either switches on or off (depending on which auto function is

chose). To cancel the delayed switch off function, turn off the air conditioner or adjust the time setting to 0.0

Temperature Controls

• Press to adjust the temperature setting.

• The default display is room temperature.

• In cooling mode, when + or - button is pressed, the set temperature is displayed and may be adjusted. After a few seconds the

display will revert back to room temperature. Temperature is only adjustable in cool mode.

Note : By pressing both + / - buttons at the same time, the display will switch between Celsius and Fahrenheit.

Fan Speed Control

The Fan Speed Control has 3 settings: Low, Medium, High. Fan speed indicator illuminates according to the selected fan speed.

Power Control

Press to turn the air conditioner on and off.

Cooling Mode

In this mode, the air conditioner cools and dehumidifies the room. To activate this function mode, press the MODE button until

the COOL indicator lightcomes on. When the cooling mode is set, the compressor will start in approximately 3 minutes. In

cooling mode, hot air is exhausted from the outdoor exhaust port and the exhaust hose must be connected to exhaust out the

hot air.Note : The air exchange hoses must vent outside the room when using cool mode.