Instructions/Assembly Guide
CONTROL PANEL
Power
Press to turn the air conditioner on and off.
Sleep Mode
Press to activate Sleep mode and the sleep light illuminates. Press SLEEP button again to stop the SLEEP operation.
Timer
Press to program timer delayed switch ON or OFF function.
Modes
Press to change modes. Controls the functions modes: COOL , DRY ,and FAN . See page 10.
Fan
Press to change fan speed. Controls the 3 fan speeds and mode: Low, Medium, and High .
The fan speed indicator lights illuminate to show the set fan speed/mode.
Up and Down buttons
Adjusts set temperature 1°F | 1°C increments or timer hours (0 - 24 hours).
NOTE: This unit is capable of displaying set temperature in Fahrenheit or Celsius. To convert from one to another, press and
hold the Up and Down buttons for 3 seconds.
Swing
Press to start the auto swing feature. When the operation is ON, press the SWING button to stop the louver at a desired angle.
LED Display
Shows the set temperature in °F or °C and the Auto-timer settings. While on FAN modes, it shows the room temperature.
Tank Full
If the internal condensation tank becomes full, the Tank Full light will turn RED and the unit will not operate until it has been
drained from the lower manual drain port.
Error Codes
E1 - Room temperature sensor error - Unplug unit and restart in 5 minutes
E2 - Evaporator sensor error - Unplug unit and restart in 5 minutes
Note: If any other error code appears on the display, unplug the air conditioner and allow it to sit undisturbed for 5 minutes. If
the error code persists when the unit is plugged back in, please contact Whynter Customer Support.
OPERATION INSTRUCTIONS
BEFORE USING YOUR APPLIANCE
• Remove the exterior and interior packing
• Before connecng the appliance to the power source, let it stand upright for approximately 4 hours. This will reduce the possi-
bility of a malfuncon in the cooling system from handling during transportaon
9