Instructions/Assembly Guide

PREPARATION
All illustrations in the manual are for explanation purpose only. Your machine may be slightly different. The actual shape
shall prevail. The unit can be controlled by the unit control panel alone or with the remote controller.
DESIGN NOTICE
In order to ensure the optimal performance of our products, the design specifications of the unit and remote control are
subject to change without prior notice.
EXHAUST HOSE INSTALLATION
The exhaust hoses and adapter must be installed or removed in accordance with the usage mode. For COOL mode, the
adapter and exhausts must be installed. For FAN or DRY mode, the adapter and exhaust hoses can oponally be removed.
CHOOSING THE RIGHT LOCATION
Your installaon locaon should meet the following requirements:
• Make sure that you install your unit on an even surface to minimize noise
and vibration.
• The unit must be installed near a grounded plug, and the lower manual
gravity drain port (found on the back of the unit) must be accessible.
• The unit should be located at least 20" from the nearest wall to en-sure
proper air conditioning. The horizontal louver blade should be at least 20"
away from obstacles.
• DO NOT cover any of the intake and exhaust vents or the remote signal
receptor of the unit, as this could cause damage to the unit.
1
2
3
4
5
6
7
8
10
11
9
1. Control Panel
2. Air Outlet
3. Handle (both sides)
4. Wheel Casters
5. Air Filter
6. Air Intake (Evaporator)
7. Air Outlet/Exhaust (Heat
Exchange)
8. Air Intake (Condenser)
9. Power Supply Cord
10. Lower Manual Drain Port
11. Upper Gravity Drain Port
12. Hose Lock Switch
20 inch
20 inch
5
12