Instructions/Assembly Guide

OPERATION INSTRUCTIONS
SLEEP MODE
In this mode, the air conditioner gradually increases the set temperature in cooling mode, decreases the noise level and conserves
energy. The temperature will then increase by another 1°C/ 1°F after an additional 30 minutes. This new temperature will remain
the same for 7 hours. To activate this function mode, press the SLEEP button until the SLEEP indicator light comes on.
AUTO RESTART
In the event of a power outage, the air conditioner restarts at the previously set function mode and settings when power is re-
stored.
CONTROLLING THE AIR FLOW DIRECTION
The louvers can be controlled to Auto-Swing or in a fixed direction. To control the air flow direction by Auto-Swing, press the
SWING button. To set the louvers in a fixed angle or direction, press SWING button while on Auto-Swing mode when desired angle
is chosen.
NOISE LEVEL
Portable air conditioners may make sounds that are not familiar to you. The sounds listed below are normal. Noise reflecting off
hard surfaces such as a floor or wall can make the sounds seem louder than they actually are.
• The compressor may make a pulsating or high-pitched sound
• Water running from the evaporator to the water tank may make a splashing sound
• Refrigerant flowing may make a gurgling sound
• Fan sound may come from front and back air vents
COMPRESSOR LOCK OUT
This portable air conditioner is optimized to operate in an ambient temperature of 61°F - 95°F (16°C - 35°C). The
compressor circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly. This prevents over-
heating of the compressor and possible circuit breaker tripping.
The portable air conditioner can be switched on by the remote control. To transmit signals from the remote control to the air
conditioner, point the front part of the remote handset towards the control panel on the air conditioner. Reception of the signal is
confirmed by a beep. The maximum signal transmission distance is approximately 8 meters / 26 feet.
• Other appliances in the same room controlled by a remote control (TV, radio, stereo, etc.), may cause interferences
• Electronic and fluorescent lamps may interfere with the signal transmissions between the remote control and the air conditioner
• Remove the batteries if the remote control is not used for long periods
REMOTE CONTROL
Power Button
Press to turn the air conditioner on and off
On / Off Timer Button
Press to program Timer Delayed Switch
ON or OFF function
Time / Temperature Set Control
● Used for adjusting the timer and
thermostat.
● The default display is room
temperature.
● When "＋" or "－" button is
pressed, the set temperature is
displayed and may be adjusted.
After a few seconds, the display will
revert back to room temperature.
Mode Button
Press to change modes. Controls the
functions modes: COOL, DRY and FAN.
Fan Speed
Controls the 3 fan speeds and mode: Low,
Medium, and High
Swing Button
Press to adjust the air flow direction
Sleep Button
Press this button to gradually increase the
set temperature in cooling mode,
decreases the noise level and conserves
energy
11